SERVICE WORK ON THE CHASSIS 13
189
Chain tension 40 … 45 mm (1.57 …
1.77 in)
» If the chain tension does not meet the specification:
– Adjust the chain tension. ( p. 189)
Finishing work
– Remove the vehicle from the center stand. ( p. 182)
13.10 Adjusting the chain tension
Warning
Danger of accidents Incorrect chain tension damages components and results in accidents.
If the chain is tensioned too much, the chain, engine sprocket, rear sprocket, transmission and rear
wheel bearings wear more quickly. Some components may break if overloaded.
If the chain is too loose, the chain may fall off the engine sprocket or the rear sprocket. As a result, the
rear wheel locks or the engine will be damaged.
– Check the chain tension regularly.
– Set the chain tension in accordance with the specification.
Preparatory work
– Raise the vehicle with the center stand. ( p. 181)
– Check the chain tension. ( p. 188)
To Next Page
Loading...
Need help?
General
