KTM 1290 Super Adventure S 2018 User Manual

TROUBLESHOOTING 22
301
Faults Possible cause Action
Malfunction indicator lamp
lights up
Fault in fuel injection system – Read out the fault memory using the
KTM diagnostics tool.
The ABS indicator lamp lights
up
ABS fuse is blown – Change the fuses in the fuse box.
( p. 264)
Wheel speeds of front and rear
wheels differ greatly
– Stop, switch off the ignition, start
again.
Malfunction in ABS – Read out the fault memory using the
KTM diagnostics tool.
High oil consumption Engine oil level too high – Check the engine oil level. ( p. 279)
Engine oil too thin (low viscos-
ity)
– Change the engine oil and oil filter and
clean the oil screens. ( p. 280)
The battery is discharged A power consumer is connected
to the socket/ACC1.
– Disconnect the power consumer from
the socket/ACC1.
– Recharge the battery. ( p. 255)
The hazard warning flasher is
switched on
– Switch off the hazard warning flasher.
– Recharge the battery. ( p. 255)
Battery is not charged by alter-
nator
– Check the charging voltage.
Ignition was not switched off
when vehicle was parked
– Recharge the battery. ( p. 255)

KTM 1290 Super Adventure S 2018 Specifications

General

Engine Type	2-cylinder, 4-stroke, V 75°
Displacement	1301 cc
Transmission	6-speed
Final Drive	Chain
Front Suspension	WP semi-active suspension USD Ø 48 mm
Rear Suspension	WP semi-active suspension monoshock
Wheelbase	1560 mm
Fuel Capacity	23 liters
Dry Weight	215 kg
Power	160 hp (118 kW) @ 8750 rpm
Torque	140 Nm @ 6750 rpm
Front Brake	2 x 320 mm discs, 4-piston calipers
Rear Brake	267 mm disc, 2-piston caliper
ABS	Bosch 9ME Combined ABS
Traction Control	MTC (Motorcycle Traction Control)
Seat Height	860/875 mm
Tires Front	120/70 R19
Tires Rear	170/60 R17