KTM 250 SX-F 2016 User Manual

7 PREPARING FOR USE 20
– Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion, or damage is found:
– Clean and dry the connector, or change it if necessary.
Difficult riding conditions are:
– Rides on dry sand. ( p. 20)
– Rides on wet sand. ( p. 20)
– Rides on wet and muddy surfaces. ( p. 21)
– Rides at high temperatures and low speeds. ( p. 21)
– Riding at low temperature and in snow. ( p. 21)
7.5 Preparing for rides on dry sand
102136-01
– Fit a dust cover on the air filter.
Dust protection device for air filter (79006920000)
Info
See the KTM PowerParts fitting instructions.
102138-01
– Fit a sand cover on the air filter.
Sand protection device for air filter (79006922000)
Info
See the KTM PowerParts fitting instructions.
600868-01
– Clean the chain.
Chain cleaner ( p. 108)
– Fit the steel sprocket.
Tip
Do not grease the chain.
– Clean the radiator fins.
– Straighten bent radiator fins carefully.
Condition
Regular use in sand
– Change the piston every 20 operating hours.
7.6 Preparing for rides on wet sand
102137-01
– Fit a waterproofing device on the air filter.
Waterproofing device for air filter (79006921000)
Info
See the KTM PowerParts fitting instructions.

KTM 250 SX-F 2016 Specifications

General

Engine Type	Single cylinder, 4-stroke
Displacement	249.9 cc
Starter	Electric starter
Fuel System	Keihin EFI, 44 mm throttle body
Ignition	Keihin EMS
Transmission	5-speed
Front Tire	80/100-21
Rear Tire	100/90-19
Seat Height	960 mm
Ground Clearance	370 mm
Bore x Stroke	78 mm x 52.3 mm
Final Drive	Chain
Front Suspension	WP USD, 48 mm
Rear Suspension	WP monoshock
Front Brake	Disc brake, 260 mm
Rear Brake	Disc brake, 220 mm
Wheelbase	1485 mm
Fuel Capacity	7 liters
Frame	Central double-cradle-type 25CrMo4 steel