11 SERVICE WORK ON THE CHASSIS 54
311691-10
Main work
– Remove all screws on the main silencer.
–
Take off silencer cap
and O-ring
.
–
Take off outer tube
and O-ring
.
–
Pull glass fiber yarn filling
off of inner tube
.
– Clean the parts that need to be reinstalled and check for damage.
–
Mount new glass fiber yarn filling
on inner tube
.
–
Slide O-ring
and outer tube
over glass fiber yarn filling
.
–
Insert O-ring
and silencer cap
into outer tube
.
– Mount and tighten all of the screws.
Guideline
Screws on the main silencer M5 7 Nm (5.2 lbf ft)
Finishing work
– Install the main silencer. ( p. 53)
11.32 Removing the fuel tank
Danger
Fire hazard Fuel is highly flammable.
The fuel in the fuel tank expands when warm and can escape if overfilled.
– Do not refuel the vehicle in the vicinity of open flames or lit cigarettes.
– Switch off the engine for refueling.
– Make sure that no fuel is spilled; particularly not on hot parts of the vehicle.
– If any fuel is spilled, wipe it off immediately.
– Observe the specifications for refueling.
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
– Avoid skin, eye and clothing contact with fuel.
– Immediately consult a doctor if you swallow fuel.
– Do not inhale fuel vapors.
– In case of skin contact, rinse the affected area with plenty of water.
– Rinse the eyes thoroughly with water, and consult a doctor in case of fuel contact with the eyes.
– Change your clothing in case of fuel spills on them.
– Keep fuels correctly in a suitable canister, and out of the reach of children.
Preparatory work
– Remove the seat. ( p. 49)
M00781-10
Main work
–
Unplug connector
of the fuel pump.
–
Clean the plug-in connection
of the fuel line thoroughly with compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve!
To Next Page
Loading...
Need help?
General
