11 SERVICE WORK ON THE CHASSIS 42
102150-11
–
Tighten screws
.
Guideline
Screw, top triple clamp M8 17 Nm
(12.5 lbf ft)
–
Tighten screws
.
Guideline
Screw, bottom triple clamp M8 12 Nm (8.9 lbf ft)
102149-11
–
Position the brake caliper. Mount and tighten screws
.
Guideline
Screw, front brake caliper M8 25 Nm
(18.4 lbf ft)
Loctite
®
243™
–
Position the brake line and clamp. Mount and tighten screws
.
Finishing work
– Install the front wheel. ( p. 73)
11.9 Removing the lower triple clamp
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 39)
– Remove the front wheel. ( p. 73)
– Remove the fork legs. ( p. 41)
– Remove the start number plate. ( p. 46)
– Remove the front fender. ( p. 46)
– Remove the handlebar cushion.
102152-10
Main work
– Remove the holder with FI warning lamp.
–
Remove screw
.
–
Remove screw
.
– Remove the upper triple clamp with the handlebar and set aside.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
102153-10
–
Remove O-ring
. Remove protective ring
.
– Remove the lower triple clamp with the steering stem.
– Remove the upper steering head bearing.
To Next Page
Loading...
Need help?
General
