8 RIDING INSTRUCTIONS 22
8.1 Checks and maintenance before putting into operation
Info
Before every trip, check the condition of the vehicle and ensure that it is safe to operate.
The vehicle must be in perfect technical condition when used.
– Check the engine oil level. ( p. 89)
– Check the front brake fluid level. ( p. 65)
– Check the rear brake fluid level. ( p. 69)
– Check the front brake linings. ( p. 66)
– Check the rear brake linings. ( p. 70)
– Check that the brake system is functioning properly.
– Check the coolant level. ( p. 83)
– Check for chain dirt accumulation. ( p. 56)
– Check the chain, rear sprocket, engine sprocket, and chain guide. ( p. 58)
– Check the chain tension. ( p. 57)
– Check the tire condition. ( p. 76)
– Check the tire air pressure. ( p. 76)
– Check the spoke tension. ( p. 76)
– Clean the dust boots of the fork legs. ( p. 40)
– Bleed the fork legs. ( p. 39)
– Check the air filter.
– Check the settings of all controls and ensure that they can be operated smoothly.
– Check all screws, nuts and hose clamps regularly for tightness.
– Check the fuel reserves.
8.2 Starting
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and death.
– Always make sure there is sufficient ventilation when running the engine.
– Use an effective exhaust extraction system when starting or running the engine in an enclosed space.
Note
Engine damage High revving speed with a cold engine negatively impacts the lifespan of the engine.
– Always run the engine warm at a low speed.
402001-10
(All SX‑F models)
–
Remove plug-in stand
.
401944-10
(XC‑F US)
–
Take the motorcycle off the side stand
and secure the side stand with the
rubber band
.
– Shift the transmission to idle.
Condition
Ambient temperature: < 20 °C (< 68 °F)
– Push the cold start button in all the way.
To Next Page
Loading...
Need help?
General
