MAINTENANCE WORK ON CHASSIS AND ENGINE 51
(XC)
– Position the brake line. Put on the clamp and mount and tighten screws .
–
Install the front wheel. x ( p. 67)
11.27Removing the fork protector x
–
Remove the fork legs. x ( p. 49)
500105-10
– Remove screws on the left fork leg. Lift off the fork protector.
– Remove the screws on the right fork leg. Lift off the fork protector.
11.28Installing the fork protector x
500105-10
– Position the fork protection on the left fork leg. Mount and tighten screws .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
– Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Install the fork legs. x ( p. 50)
11.29Removing the front fender
500092-10
– Remove screws . Remove the front fender.
– Make sure the spacers remain in place.
11.30Installing the front fender
500092-10
– Ensure that the spacers are mounted in the fender.
– Position the front fender. Mount and tighten screws .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Info
Make sure the holding lugs engage in the start number plate.
To Next Page
Loading...
Need help?
General
