MAINTENANCE WORK ON CHASSIS AND ENGINE 78
400243-10
– Stand the motorcycle upright on a horizontal surface.
– Remove the radiator cap.
– Check the coolant level in the radiator.
Coolant level above the radiator fins. 10 mm (0.39 in)
» If the level of the coolant does not meet specifications:
– Correct the coolant level.
Alternative 1
Coolant ( p. 130)
Alternative 2
Coolant (mixed ready to use) ( p. 130)
– Mount the radiator cap.
11.85Draining the coolant x
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
– Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the
engine and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
– Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immedi-
ately. Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.
Condition
The engine is cold.
– Stand the motorcycle upright.
– Place a suitable container under the water pump cover.
B00043-11
(All 125/150/200 models)
– Remove screw . Remove radiator cap .
– Completely drain the coolant.
– Mount screw with a new seal ring and tighten it.
Guideline
Drain plug, water pump cover M10x1 15 Nm
(11.1 lbf ft)
B00044-11
(All 250/300 models)
– Remove screw . Remove radiator cap .
– Completely drain the coolant.
– Mount screw with a new seal ring and tighten it.
Guideline
Drain plug, water pump cover M10x1 15 Nm
(11.1 lbf ft)
To Next Page
Loading...
Need help?
General
