MAINTENANCE WORK ON CHASSIS AND ENGINE 90
– Start the engine and check that it is oil-tight.
– Check the gear oil level. ( p. 88)
11.110Adding gear oil x
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
The gear oil must be added when the engine is cold.
– Place the motorcycle on a level surface.
B00049-10
(All 125/150/200 models)
– Remove gear oil level check screw .
B00050-10
(All 250/300 models)
– Remove gear oil level check screw .
B00053-11
– Remove screw cap .
– Add gear oil until it flows out of the hole of the gear oil level check screw.
Engine oil (15W/50) ( p. 130)
– Mount and tighten the gear oil level check screw.
Guideline
Screw, gear oil level check M6 10 Nm (7.4 lbf ft)
– Mount and tighten screw cap .
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
– Start the engine and check that it is oil-tight.
To Next Page
Loading...
Need help?
General
