KTM 250 XC TPI User Manual

SERVICE SCHEDULE 9
33
9.1 Additional information
Any further work that results from the compulsory work or from the recommended work must be ordered sepa-
rately and invoiced separately.
Different service intervals may apply in your country, depending on the local operating conditions.
Individual service intervals and scopes may change in the course of technical developments. The most up-to-date
service schedule can always be found on KTM Dealer.net. Your authorized KTM dealer will be happy to advise
you.
9.2 Required work
Every 40 operating hours
Every 20 operating hours
Every 10 operating hours
After 5 operating hours
After 1 operating hour
Read out the fault memory using the KTM diagnostics tool. ○ ○ ● ● ●
Check that the electrical system is functioning properly. ○ ● ● ●
Check and charge the 12-V battery. ● ● ●
Change the gear oil. ( p. 118) ○ ●
Check the front brake linings. ( p. 81) ● ● ●
Check the brake linings of the rear brake. ( p. 87) ● ● ●
Check the brake discs. ( p. 78) ● ● ●
Check the brake lines for damage and leakage. ● ● ●
Check the rear brake fluid level. ( p. 85) ● ● ●
Check the free travel of the foot brake lever. ( p. 84) ● ● ●
Check the frame. ( p. 73) ● ● ●
Check the link fork. ( p. 73) ● ● ●
Check the fork bearing for play. ● ●
Check the heim joint for play. ● ● ●
Check the shock absorber linkage. ● ● ●
Check the tire condition. ( p. 94) ○ ● ● ●
Check tire pressure. ( p. 94) ○ ● ● ●
Check the wheel bearing for play. ● ● ●
Check the wheel hubs. ● ● ●
Check the rim run-out. ○ ● ● ●
Check the spoke tension. ( p. 95) ○ ● ● ●
Check the chain, rear sprocket, engine sprocket, and chain guide. ( p. 71) ● ● ●
Check the chain tension. ( p. 69) ○ ● ● ●
Grease all moving parts (e.g. side stand, hand lever, chain, etc.) and check for smooth
operation.
● ● ●
Check/correct the fluid level of the hydraulic clutch. ( p. 75) ● ● ●
Check the front brake fluid level. ( p. 79) ● ● ●
Check the free travel of the hand brake lever. ( p. 78) ● ● ●
Check steering head bearing play. ( p. 53) ○ ● ● ●
Change the spark plug and spark plug connector. ● ●
Check all hoses (e.g. fuel, cooling, bleeder, drainage hoses, etc.) and sleeves for crack-
ing, tightness, and correct routing.
○ ● ● ●

KTM 250 XC TPI Specifications

General

Displacement	249 cc
Bore x Stroke	66.4 mm x 72 mm
Transmission	6-speed
Starter	Electric starter
Front Brake	Disc brake, 260 mm
Rear Brake	Disc brake, 220 mm
Engine Type	2-stroke
Fuel System	TPI (Transfer Port Injection)
Frame	Central Tube Frame, Made of Chrome Molybdenum Steel
Front Suspension	WP Xplor 48, USD fork
Rear Suspension	WP XPLOR Shock with Linkage
Fuel Capacity	8.5 liters