TUNING THE CHASSIS 23
700524-01
– Loosen screws on the lower triple clamp.
– Loosen screw on the upper triple clamp.
Info
Loosen the screws to the point where the fork legs can be moved without
damaging it.
Make the adjustments first on one fork leg and then on the other.
– Adjust the fork overhang with the upper triple clamp.
Guideline
10… 17 mm (0.39… 0.67 in)
– Tighten screw .
Guideline
Screw, top triple clamp M8 25 Nm
(18.4 lbf ft)
– Fully tighten screws .
Guideline
Screw, bottom triple clamp M6 10 Nm (7.4 lbf ft)
– Repeat the adjustment on the other fork leg.
Info
The setting of the vehicle level via the fork legs must be identical on both
fork legs.
9.9Adjusting seat height x
Warning
Danger of accidents Modifications to the suspension settings can seriously alter the vehicle's ride behavior.
– Following modifications, ride slowly at first to get the feel of the new ride behavior.
– Raise the motorcycle with a lift stand. ( p. 25)
700521-01
– Hold the rear wheel with the swingarm and remove screw .
– Position the shock absorber according to the required seat height.
Guideline
Low seat position (standard)
High seat position
– Mount and tighten screw .
Guideline
Screw, top shock absorber M10 45 Nm
(33.2 lbf ft)
– Remove the motorcycle from the lift stand. ( p. 25)
9.10Handlebar position
400565-10
On the upper triple clamp, there are 2 holes at a distance of to each other.
Distance between holes 15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of from the center.
Distance between holes 3.5 mm (0.138 in)
The handlebar supports can be mounted in 4 different positions.
To Next Page
Loading...
Need help?
General
