13 WHEELS 73
13.5 Checking the rim run-out
Warning
Danger of accidents Instable handling due to incorrect spoke tension.
– Ensure that the spoke tension is correct.
Info
A loose spoke can cause wheel imbalance, which leads to more loose spokes in a short time.
If the spokes are too tight, they can break due to local overload.
Check the spoke tension regularly, especially on a new motorcycle.
400998-01
– Check the axial run-out and radial run-out of the rim.
Axial run-out
outside of the rim joint < 1.8 mm (< 0.071 in)
Radial run-out
outside of the rim joint < 1.8 mm (< 0.071 in)
» If the measured value is greater than the specified value:
– Center the rim.
Info
Center the rim by tightening the spoke nipple on the opposite side of
the rim run-out. Change the rim if it is excessively deformed.
– Correct the spoke tension.
13.6 Front wheel
13.6.1 Removing the front wheel
Preparatory work
– Raise the motorcycle with the lift stand. ( p. 10)
601807-10
Main work
– Press the brake caliper by hand on to the brake disc in order to press back the
brake pistons.
601808-10
– Remove screw 1.
– Loosen screw 2.
To Next Page
Loading...
Need help?
General
