12 BRAKE SYSTEM 105
400418-10
–
Check that leaf spring
in the brake caliper and sliding plate
in the brake caliper
support are seated correctly.
– Insert the new brake linings, insert the pin, and mount the cotter pin.
Info
Always change the brake linings in pairs.
– Operate the hand brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
B01958-12
–
Adjust the brake fluid level to level
.
Guideline
Measurement
5 mm (0.2 in)
Brake fluid DOT 4 / DOT 5.1 ( p. 195)
– Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
12.8 Checking the free travel of foot brake lever
Warning
Danger of accidents Brake system failure.
– If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to over-
heating. Adjust the free travel on foot brake lever according to specifications.
To Next Page
Loading...
Need help?
General
