81PERIODIC SERVICE OF THE TRACTOR
BReplacing Transmission Oil Filter
To avoid personal injury:
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the oil filter.
2. Put a film of clean transmission oil on rubber seal of
new filter.
3. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the
transmission fluid level will decrease a little. Make sure
that the transmission fluid does not leak through the
seal, and check the fluid level.
Top up if necessary.
5. Properly dispose of used oil.
A To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
BChanging Front Axle Case Oil
1. Park the machine on a firm, flat and level surface.
2. To drain the used oil, remove the right and left drain
plugs and oil gauge at the front axle case and drain
the oil completely into the oil pan.
3. After draining reinstall the drain plugs.
4. Remove the right and left breather plugs.
5. Fill with new oil up to the upper notch on the dipstick.
(See "LUBRICANTS" in "MAINTENANCE OF THE
TRACTOR" section)
A After ten minutes, check the oil level again; add oil to
prescribed level.
6. After filling, reinstall the oil gauge and breather plugs.
(1) Filter
Oil capacity 4.7 L(5.0 U.S.qts.)
(1) Breather plug
(2) Oil gauge with dipstick
(3) Drain plug
(A) Oil level is acceptable
within this range
To Next Page
Loading...
Need help?
General
