45THREE-POINT HITCH & DRAWBAR
BRemoving the 3-Point Hitch
When installing the backhoe, remove the 3-point hitch.
1. Remove the lynch pin and the top link pin. Then
remove the top link.
2. Remove the snap ring and the clevis pin. Then remove
the left and right lifting rod.
3. Remove the hair pin and stopper pin. Then remove the
check chain plate and lower links.
BInstalling the 3-Point Hitch
1. Follow the reverse procedure mentioned above.
(1) Top link
(2) Clevis pin
(3) Snap ring
(4) Lifting rod (Left)
(5) Lower link
(6) Stopper pin
(7) Hair pin
(8) Check chain plate
(9) Top link pin
(10) Lynch pin
(11) Lifting rod (Right)
To Next Page
Loading...
Need help?
General
