93REMOVING THE LOADER
11.Stop the engine.
12.Slowly release all hydraulic pressure by moving the
loader control lever in all directions.
13.Disconnect the four hoses with quick couplers at the
control valve and place them on the right side of the
boom.
14.Place the protective caps and plugs on the quick
coupler ends.
15.Start the engine and slowly back the tractor away from
the loader.
STORAGE OF THE LOADER
1. Store the loader in a clean dry place.
2. Make sure the loader is properly supported.
3. Attach the protective plugs and caps to the couplers to
protect from dust.
4. Check hydraulic hoses and connections. Repair or
replace if necessary.
5. Repair or replace any worm, damaged or missing
parts.
6. Lubricate loader as described "LUBRICATION" in
"MAINTENANCE OF THE LOADER" section.
7. Apply a coat of grease to all exposed cylinder rods and
mounting pins to prevent rust.
8. Repaint worn or scratched parts.
(1) Protective plug
To Next Page
Loading...
Need help?
General
