PERIODIC SERVICE OF THE TRACTOR68
BChecking and Refueling
To avoid personal injury:
A Do not smoke while refueling.
A Be sure to stop the engine and remove the key
before refueling.
1. Turn the key switch to "ON", check the amount of fuel
by fuel gauge.
2. Fill fuel tank when fuel gauge shows 1/4 or less fuel in
tank.
3. Use grade No.2-Diesel fuel at temperatures above
-10 (14).
Use grade No.1-Diesel fuel at temperatures below
-10 (14).
A Do not permit dirt or trash or water to get into the fuel
system.
A Be careful not to let the fuel tank become empty,
otherwise air will enter the fuel system, necessitating
bleeding before next engine start.
A Be careful not to spill fuel during refueling. If a spill
should occur, wipe it off at once, or it may cause a fire.
A To prevent condensation (water accumulation) in the
fuel tank, fill the tank before parking overnight.
A No.2-D is a distillate fuel of lower volatility for engines
in industrial and heavy mobile service.
A Grade of Diesel Fuel Oil According to ASTM D975
(SAE J313 JUN87)
BChecking Engine Oil Level
To avoid personal injury:
A Be sure to stop the engine and remove the key
before checking the oil level.
1. Park the machine on a firm, flat and level surface.
2. Check engine oil before starting the engine, or, after 5
minutes or more when the engine has been stopped.
3. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS" in "MAINTENANCE OF THE
TRACTOR" section)
(1) Fuel tank cap
Fuel tank capacity 25L (6.6 U.S.gals.)
Flash Point,
()
Water and
Sediment,
volume
%
Carbon
Residue on,
10 percent
Residuum, %
Ash, weight
%
Min Max Max Max
52
(125)
0.05 0.35 0.01
Distillation
Tempera-
tures,
()
90% Point
Viscosity
Kinematic
cSt or
mm /s
at 40
Viscosity
Saybolt,
SUS
at 100
Sulfur
weight
%
Copper
Strip
Corro-
sion
Cetane
Num-
ber
Min Max Min Max Min Max Max Max Min
282
(540)
338
(640)
1.9 4.1 32.6 40.1 0.50 No.3 40
(1) Oil inlet
(2) Dipstick
(A) Oil level is acceptable within this range.
To Next Page
Loading...
Need help?
General
