7SAFE OPERATION
18.Be extra careful when operating the tractor on a slope,
always operate up and down, never across the slope.
Do not operate on steep slopes or unstable surfaces.
19.When operating another implement on a hillside, be
sure to remove the loader to reduce the risk of rollover.
20.Carry loader boom at a low position during transport.
(You should be able to see over the bucket.)
21.Allow for the loader length when making turns.
1. When loader work is complete and parking or storing,
choose flat and hard ground. Lower the loader boom
to the ground, stop the engine, set the brakes and
remove the key before leaving the tractor seat.
2. Make sure the detached loader is on stands and on a
hard, level surface.
3. Before disconnecting hydraulic lines, relieve all
hydraulic pressure.
4. Do not remove the loader from the tractor without an
approved bucket attached.
1. Always wear safety goggles when servicing or
repairing the machine.
2. Do not modify the loader. Unauthorized modification
may affect the function of the loader, which may result
in personal injury.
3. Do not use the loader as a work platform or a jack to
support the tractor for servicing or maintenance.
Securely support the tractor or any machine elements
with stands or suitable blocking before working
underneath.
For your safety, do not work under any hydraulically
supported devices. They can settle or suddenly leak
down or be accidentally lowered.
4. Escaping hydraulic oil under pressure can have
sufficient force to penetrate the skin, causing serious
personal injury. Do not use hands to search for
suspected leaks. If injured by escaping fluid, obtain
medical treatment immediately.
5. Do not tamper with the relief valve setting. The relief
valve is pre-set at the factory. Changing the setting
can cause overloading of the loader and tractor which
may result in serious personal injury.
6. When servicing or replacing pins in cylinder ends,
bucket, etc., always use a brass drift and hammer.
Failure to do so could result in injury from flying metal
fragments.
3. AFTER OPERATING THE LOADER
4. SERVICING THE LOADER
To Next Page
Loading...
Need help?
General
