U20-3, U25-3 WSM Machine body (Service section)
II-S-30
[3] Dozer lever
Dozer lever assembly view
1) Assembling Procedure
1. Adjust the levers neutral positions, referring
to the figure at left.
2. Do not bend the end of the cable outer casing.
* Ensure a straight section of at least
20mm.
3. Allowable cable bending radius
To be over 150R
4. Check items after setup
1. Make sure the valve spool works all
over the stroke.
2. Make sure the valve spool moves smoothly.
5. Parts list
Dozer cable route
 Guide
No.
 Cover (right, top) RB411-4476Δ

Move the lever full stroke to see if the lever does not
hit the cover (right, top).
No. Part No. Part name Q’ty Remarks
1 56501-17531 Grip 1
2 RB411-6577 Cable (dozer) 1
3 04013-60100 Plain washer 2
4 05525-61000 Snap pin 2
To Next Page
Loading...
Need help?
General
