10. A.C. GENERATOR/STARTER CLUTCH
10-2
G-DINK 300i
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• All servicing operations and inspections in this section can be made with the engine installed.
• Drain the coolant before removing the right crankcase cover.
• Be careful not to drain the coolant when the engine temperature is high. (Perform this operation
when the engine is cold.)
• Drain the coolant into a clean container.
• Drain the engine oil into a clean container before removing the right crankcase cover.
• When the right crankcase cover is installed, fill with the recommended engine oil and coolant.
Then, bleed air from the water jacket.
SPECIAL TOOLS
Flywheel puller
Flywheel holder
SPECIFICATIONS
Item Standard (mm) Service Limit (mm)
Starter driven gear I.D. 22.026～22.045 22.15mm
Starter driven gear O.D. 42.195～42.208 41.5mm
TORQUE VALUES
Flywheel nut : 53.9～63.7N-m
TROUBLESHOOTING
Starter motor rotates but engine does not start
• Faulty starter clutch
• Starter motor rotates reversely
• Weak battery
To Next Page
Loading...
Need help?
General