13. FUEL INJECTION SYSTEM
13-9
G-DINK 300i
SELF-DIAGNOSTIC
PROCEDURES WITHOUT
DIAGNOSTIC TOOL
SELF-DIAGNOSTIC PROCEDURES
Place the scooter on its main stand.
Put the side stand up and the engine stop
switch is at “RUN”.
● Turn key to On position.
● The CELP will be lighting for two seconds
and then off.
● If the engine has problem, the CELP will
blink to show the failure codes.
● There’re 11 failure codes for the KEHIN
system.
If the vehicle gets more failure codes, the
CELP will be blinking from a lower number,
then show the higher number after three
seconds. All failure codes would be
appeared repeatedly.
It can be performed without diagnostics
program.
No matter when the “CELP” illuminated
while riding condition, should find out
the cause of the problem as soon as
Fi indicato
Battery warning indicator
RUN
Upward side
stan
To Next Page
Loading...
Need help?
General