KYMCO G-DINK 300i Service Manual

13. FUEL INJECTION SYSTEM
13-2
G-DINK 300i
SPECIFICATIONS
ITEM SPECIFICATIONS
Throttle body identification number LHG7
Idle speed 1600±100 rpm
Throttle grip free play 2～6 mm (1/16～1/4 in)
Fuel injector resistance (at 20°C/68°F) 11.7±0.6Ω
Float at full position 1100±33 Ω Fuel pump resistance
(at 20°C/68°F)
Float at empty position 100±3 Ω
Fuel pump standard pressure (at 40 L/Hr) 294±6 kPa (3 Bar)
At -20°C/-4°F 18.8 KΩ
At 40°C/104°F 1.136 KΩ
Water temperature
sensor resistance
At 100°C/212°F 0.1553 KΩ
Intake pressure sensor (MAP) pressure (at 1～
4.2 V)
13.332 kPa (0.13332 kgf/ cm
2
, 1.89 psi)～
119.99 kPa (1.1999 kgf/ cm
2
, 17.04 psi)
Inductive ignition coil
Primary: 3.57~4.83Ω
Secondary: 10.42~14.49KΩ
Throttle position sensor (TPS) resistance (at
20°C/68°F)
3500~6500Ω
Crank position sensor voltage (at 200 rpm) 100~130Ω
O
2
heater sensor resistance (at 20°C/68°F) 6.7～9.5 Ω (engine warming condition)
Standard 0.4～1.4 V
Tilt switch voltage
Over 65° (fall down) 3.7～4.4 V

KYMCO G-DINK 300i Specifications

General

Brand	KYMCO
Model	G-DINK 300i
Category	Scooter
Language	English