3. INSPECTION/ADJUSTMENT
3-20
MXU 500
3. Use a brush to remove carbon deposits
from the spark arrester screen. Be careful
to avoid damaging the spark arrester
screen. The spark arrester must be free of
breaks and holes. Replace, if necessary.
Check the gasket. Replace, if necessary.
4. Install the spark arrester and the gasket in
the muffler and tighten the three bolts
securely.
DRIVE SHAFT BOOTS
Check the protective boots for holes or
tears.
If any damage is found, have them replaced.
To Next Page
Loading...
Need help?
General
