KYMCO MXU 500 User Manual

3. INSPECTION/ADJUSTMENT
3-29
MXU 500
7. Turn the rod clockwise or
counterclockwise to align the joint ball in
the rod with the hole on the shift arm,
then install and tighten the bolt and nut.
8. Tighten the lock nuts of the rod.
CABLE INSPECTION AND
LUBRICATION
Inspect the cable sheath.
Replace if damage.
Check the cable operation.
Lubricate or replace if unsmooth operation.
LEVER LUBRICATION
Lubricate the pivoting parts of each lever.
ADJUSTING THE REAR BRAKE
LIIGHT SWITCH (BRAKE
PEDAL)
1. Loosen the lock nut.
2. Turn the adjusting nut clockwise or
counterclockwise until the rear brake
light comes on at the proper time.
3. Tighten the lock nut securely.
Adjuste
r
Lock Nu
t
Damaged cable sheath may cause
corrosion and interfere with the cable
movement. An unsafe condition may
result so replace such cable as soon as
possible.
＊
Hold cable end high and apply several
dro
p
s of lubricant to cable.
＊
When align the joint ball in the rod with
the hole on the shift arm. Always keep
the joint ball original position, do not
turn the joint ball.
＊

KYMCO MXU 500 Specifications

General

Brand	KYMCO
Model	MXU 500
Category	Offroad Vehicle
Language	English