16. BRAKE SYSTEM
16-11
MXU 500
FRONT BRAKE FLUID
CHANGE/AIR BLEED (OFF
ROAD)
BRAKE FLUID CHANGE
Place the machine on the level ground and
set the handlebar upright.
Remove the two screws from the brake fluid
reservoir cap.
Connect a transparent hose to the brake
caliper bleed valve (right and calipers) and
then loosen the bleed valve nuts.
Use a syringe to draw the brake fluid out
through the hose. Then, tighten the bleed
valve nuts.
Torque: 0.6 kgf-m (6 Nm, 4.32 lbf-ft)
Fill the brake reservoir with brake fluid.
Use shop towels to cover plastic parts
and coated surfaces to avoid damage
caused by splash of brake fluid.
＊
Cap
Reservoi
To Next Page
Loading...
Need help?
General
