KYMCO X-Town 300 User Manual

CONTROLS & FEATURES
ABS indicator light
The ABS indicator light is located on the right side of
the multifunction meter. This ABS system will
self-diagnose itself, if it’s normal, the indicator light will
come on when the ignition switch is turned on and
goes off shortly after the vehicle starts moving. The
ABS indicator light will stay off as long as the ABS
system works normally.
If an ABS fault is detected by the ABS ECU, the ABS
indicator will light on and stay on until the fault is
resolved. Even there’s an ABS system failure, the
system will work normally in conventional braking
condition just like a vehicle without ABS system.
▆NOTE: If the ABS indicates a fault, it’s very important to make
the authorized KYMCO dealer to check the ABS system
immediately.
15

KYMCO X-Town 300 Specifications

General

Cooling System	Liquid cooled
Maximum Torque	22.5 Nm @ 6500 rpm
Transmission	CVT
Front Suspension	Telescopic fork
Rear Suspension	Dual shocks
Front Brake	Disc
Rear Brake	Disc
Front Tire	120/70-15
Seat Height	800 mm
Width	800 mm
Fuel Capacity	12.5 Liters
Engine Type	4-stroke, single cylinder
Fuel System	Electronic Fuel Injection