8-144
Default Setting (System Menu)
LDAP Security
Select the communication protocol according to the type of security employed by the LDAP server. The default setting
is Off.
NOTE: LDAP must be set to On in Protocol Detail on page 8-136.
The table below shows the available settings.
* You can change the port number using COMMAND CENTER.
Use the procedure below to make the setting.
1 In the Sys. Menu/Count. menu, press the U or V key to
select [System], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
2 The System menu appears.
3 Press the U or V key to select [Network Setting].
Item Description
Off Do not use security employed by the LDAP server.
SSL/TLS Encryption is applied any data communication. To enable LDAP
security, the LDAP port may have to be changed according to the
server settings. Typically, 636* for SSL/TLS is well-known LDAP
port.
STARTTLS Encryption is applied any data communication. Typically, 389* for
STARTTLS is well-known LDAP port.
To Next Page
Loading...
Need help?
General