Chapter 7 Emulation
7-114
Default States (DF)
Initial Conditions (IN)
Table 7.42. Default States (DF)
Function Equivalent Instruction Default Value
Plotting mode PA; Absolute (plotter units)
Polygon mode PM0; PM2; Empty polygon
Line type LT; Solid line
Line pattern length LTn,4; 4% of distance between P1 and P2
Scaling SC; Off (plotter units used for x- and y-coordinates)
Input window IW; Set to hard-clip limits
Circle and arc resolution – 5 degrees
Symbol mode SM; Off
Tick length TL; x-axis: 0.5 % of | P2y - P1y |
y-axis: 0.5% of | P2x - P1x |
Mask value IM233,0,0; All errors recognized, but no response to service request
or parallel port.
Fill type FT; Type 1 (bidirectional fill)
Fill spacing FT; 1% of distance between P1 and P2 (used only in fill types
3 and 4)
Fill angle FT; 0 degrees
Pen thickness PT; 0.3 mm (fill spacing for fill types 1 and 2)
Label origin – Current pen position
Relative direction DR1,0; Horizontal characters
Relative size SR; Character width: 0.75% of | P2x - P1x |
Character height: 1.5% of | P2y - P1y |
Character space ES 0, 0; None
Character slant SL; 0 degrees
Label buffer BL ETX; None
Label terminator DT ETX; ETX (ASCII code 3)
Label origin LO; Position number
Character set SS; Standard character set
Standard character set CS0; Character set 0
Code tolerance CT; Angle mode of AA, AR, CI, or WG
Alternate character set CA0; Character set 0
Table 7.43. Initial Conditions (IN)
Function Equivalent instruction Initial condition
Default conditions DF; Default values
Scaling points IP; Initialized according to paper size
Coordinate system rotation RO; 0 degrees (default setting)
To Next Page
Loading...
Need help?
General