To Next Page

To Previous Page

2-9

Drawing Circles

The CIR (draw circle) command draws a circle of a specified radius using the line thick-

ness set by the SPD (set pen diameter) command. The circle drawn is centered on the

current cursor position; the position of the cursor remains unaffected. See the following

example:

!R! RES;

UNIT C;

SPD 0.1;

MZP 8, 8;

CIR 1;

CIR 2;

CIR 3;

PAGE;

EXIT;

Figure 2. 7. Circles

Lines 1, 2 and 3 start PRESCRIBE mode, reset the printing system to its default parame-

ters, establish the unit of measurement as centimeters, and set the line width to 0.1 centi-

meters.

Next, the MZP command moves the cursor to the point that is 8 centimeters to the right

of the left edge limit and 8 centimeters below the top edge limit.

Lines 5, 6, and 7 draw three circles with radii of 1, 2, and 3 centimeters.

Drawing Filled Shapes

The standard graphics mode provides two types of filled shapes: arcs and blocks. Such

shapes are filled with one of the printing system’s predefined patterns, or with a user

defined pattern.

Filled areas of other shapes can be printed using path mode graphics. For details, see the

explanation in section Path Mode Graphics on page 16.

Kyocera ECOSYS FS-3920DN Technical Reference Manual

Other manuals for Kyocera ECOSYS FS-3920DN