164
7 Operating Control and Displays
7.3 Operation, Controls and Display with CMS Remote Software
7.3.1 Remote Software
The CMS Remote Software visualises parameter and curve data from the devices on the
LAMTEC SYSTEM BUS (LSB). The software is used to edit and store values.
Once a connection is established, the current data from the device can be accessed. Special
screens can then be used to change individual parameters, delete curves or program curve
set points.
The current state of the CMS, which is determined by the parameter settings and curve data,
can be stored as a dataset on the PC (as a backup). These dataset backups can also be load-
ed back into the CMS at a later point in time in order to restore a specific CMS state.
The previous pages have described the most important activities that can be completed using
the CMS Remote Software. The following chapters describe the menu paths in the CMS Re-
mote Software with their corresponding windows. Windows already described in the previous
chapters are only given a reference back to the corresponding chapter.
7.3.1.1 Installation Prerequisites
System requirements:
• PC with Windows XP operating system or later
• Administrator rights for installation (setup)
• Screen resolution of at least 1024 × 768 pixels
7.3.1.2 Installing the Software
Description of the Symbols
Click mouse button (left click)
Read
Fill out
Important
To Next Page
Loading...
Need help?
General
