13 Care and Transport
13.1 Storage
Respect the temperature limits when storing the equipment, particularly in
summer if the equipment is inside a vehicle. Refer to 14 Technical Data for
information about temperature limits.
The battery type is LiPo (Lithium-Ion-Polymer).
Refer to the enclosed Leica GKL352 Quick Guide or documentation on https://
myworld.leica-geosystems.com for details.
•
Charge/discharge the battery
•
Obtain information about battery charge status
☞
Check the Smart Battery GEB374 for ination or damage. You must
never use problematic batteries.
☞
Charge the Smart Battery GEB374 at least once every 3 months to
60% for optimal storage and lifetime.
☞
It is recommended to store the battery at around +20 to +25 °C.
☞
Always remove the Smart Battery GEB374 from the BLK2FLY if not
operated in order to prevent battery damage.
13.2 Cleaning and Drying
Only use a damp microbre cloth to clean the BLK2FLY. Do not use detergent
on carbon bre parts. Use a brush to remove loose dust.
NOTICE
Prevent scratching the LiDAR lighthouse
▶
Remove particles very careful. Do not scratch the LiDAR lighthouse.
13.2.1 Dome Cleaning Procedure
The dome must be kept clean. The instructions must be followed as described
in this chapter to clean the dome.
CAUTION
Before any cleaning procedure, ensure that the instrument is switched off and
the battery has been removed.
Using a compressed gas duster or canned air, remove dust and debris from
surface of the dome.
☞
Never rub off dust or debris as this will scratch the glass and so
possibly cause permanent damage to the special optical coatings.
Soiling of the glass pane can cause extreme measurement errors and there-
fore useless data!
☞
All soiling that is visible on the glass pane has to be removed, except
for single small dust particles that adhere inevitably.
Product
Smart Battery GEB374
General
General cleaning
information
Dust and debris on
the dome
Cleaning of the
camera lenses
106 Care and Transport
To Next Page
Loading...
Need help?
General
