Lewmar V1 User Manual

12
MODEL
CURRENT DRAW AT
WORKING LOAD
BREAKER SUPPLIED AMPs
CSA TO MEET ISO 10133
ANNEX A FOR 20 M
AWG TO MEET
ABYC E11 FOR L= 66 FEET
V1 126 90 25 2
V2 12V 120 90 25 2
V2 24V 60 50 10 8
V3 12V 131 110 25 2
V3 24V 70 90 16 8
V4 12V 125 150 25 2
V4 24V 70 110 10 8
V5 12V 120 150 25 2
V5 24V 60 110 10 8
V6 90 150 16 6
Installation of this product should meet the regulations and standards or codes of practice relevant to the cra
to which it is being fitted. As a minimum the installer should conform ISO 10133.
Lewmar recommends the installer use cable with insulation rated at 90°C or higher.
Length = Length of cable from battery ‘+’ terminal and back to battery ‘-’ terminal including breaker and
switch gear if fitted
Cable size guide given is for guidance only.
It is the responsibility of the installer to confirm the capacity and voltage drop for the installation. If in any doubt,
contact your local marine electrician.
GB
5.4 Control switch installation
MODEL CIRCUIT BREAKER CONTACTOR CONTROL BOX
V1/Sport
90 A (68000349) 68000318 68000129
V2/Sport
90 A (68000349) 68000318 68000129
V2/Sport
50 A (68000348) 68000319 68000130
V3/Sport
110 A (68000350) 68000318 68000129
V3/Sport
90 A (68000349) 68000319 68000130
V4
150 A (68000351) 68000320 18000200
V4
110 A (68000350) 68000321 18000237
V5
150 A (68000359) 68000318 68000128
V5
110 A (68000350) 68000318 68000130
V6
150 A (68000351) 68000321 18000237
WIRELESS REMOTE 3 BUTTON WINDLASS ONLY WIRELESS REMOTE 5 BUTTON WINDLASS AND THRUSTER
68000967 68000968
NOTE: Wireless remote also
available.
NOTE: Wireless remote can only
be used if a contactor is fitted.
See wireless remote instructions
for wiring details.

Lewmar V1 Specifications

General

Brand	Lewmar
Model	V1
Category	Marine Equipment
Language	English