7.2 Power up/down
To release anchor.
1. Models V1-3
Check fall-safe pawl is in vertical disengaged position and held clear by fall safe lever.
2. Models V4-5
Check pawl is in disengaged position.
V6 & V-Sport versions
Operate as below, this model has no fall-safe pawl.
3. Release any anchor locks.
4. When safe, operate DOWN control.
To retrieve anchor.
When retrieving the anchor rode, ensure the top nut is tight
Note: For V6 only, Tighten top but to 250Nm to achive maximum load.
Retrieving the anchor is the reverse to the above.
NOTE: Models V1-3 fall-safe does not need to be disengaged during retrieval as it acts as a rachet.
When safe, operate the UP control. When anchor has been retrieved and stowed, the fall-safe pawl should be
left engaged.
NOTE: Remember, on models V1-3 the fall-safe does need to be disengaged before anchor can be let go again.
Once anchor is retrieved, ensure it is adequately secured to an independent strong point.
WARNING!
Check Fall-Safe pawl
is disengaged and
held clear by Fall-Safe
lever - Except Sport
& V6.
To Next Page
Loading...
Need help?
General
