Installation Environment
Since the installation environment affects the printer, install the printer on a mounting stand or a desk at a place suitable for
the printer operation.
The following gives the ranges of temperature and humidity acceptable for printer operation.
• Acceptable environment
• Temperature: 10°C to 32.5°C
• Humidity: 15% to 80%
• Recommended environment
• Temperature: 17.5°C to 27°C
• Humidity: 15% to 80%
Do not install the printer in the following places:
• In a location subject to direct sunlight
• Near an air conditioner, or where it is subject to direct cool or warm drafts, or radiated heat
• Where it is subject to exhaust discharged directly from a printer
• Where the temperature or humidity changes significantly (Take care so that the printer is not subject to
condensation)
• Where it is subject to excessive dust or corrosive gases
• In a location such as a laboratory, where chemical reactions could occur
• Where an ultrasonic humidifier is being used
• In a poorly ventilated location
• Near equipment which generates electrical noise or strong magnetic fields
• Where it is subject to vibrations or shocks
• Anywhere that cannot stand the mass of the printer (about 29 kg for the printer with consumables, and about 35 kg
for the maximum printer configuration, including the options)
• In an uneven place or mounting location is not level
• Where it may be caused to slide or where it is sloped
• On more than one stand
To Next Page
Loading...
Need help?
General
