Lexmark Dot Matrix Manual

To change the administrative group name, run one of the following scripts:
Linux
# /usr/local/lexmark/setup.lexprint
Solaris and HP-UX
# /opt/lexmark/setup.lexprint
IBM AIX
# /usr/lpp/lexprint/setup.lexprint
Adding or removing a user from the administrative group
Users who are part of the administrative group can open the printer driver with permissions and perform
administrative tasks. Users who are not part of this group can only change their personal settings and maintain their
printer groups. User settings are stored in the user's home directory.
Add users to the administrative group by adding the user's name to the Administrative group located in
the /etc/group file. For information about changing the Administrative UNIX group name, see “Changing an
administrative group name” on page 16.
Remove a user from the administrative group by removing the username from the UNIX group.
Creating virtual devices
Before creating virtual devices
Before you can create a virtual device, you must gather the following information:
• The connection method for the virtual device
• For network printers—the host name or IP address and the SNMP community name
• For local printers—the connection type (parallel, serial, or USB) and the physical device file name
Creating virtual devices using the Device Manager
1 Open the printer driver.
2 Click Device Manager.
3 Click Add.
4 Click Network Attached Printer or Locally Attached Printer.
If the printer is attached locally, continue with step 5 on page 18. If the printer is attached to a network, go to
step 6 on page 18.
17

Lexmark Dot Matrix Specifications

General

Brand	Lexmark
Model	Dot Matrix
Category	All in One Printer
Language	English