To Next Page

To Previous Page

Using the Print and Hold setting

When sending a job to the printer, you can hold a job in the printer memory using the printer driver. When you are

ready to print the job, access the printer control panel menus to select the held job you want to print.

1 Open the print queue properties.

For more information, see “Changing the print queue properties” on page 21.

2 Click Print and Hold.

3 Select the type of print and hold setting you want to apply.

• Select Off if you do not want to hold your print jobs.

• Select Confidential if you want to hold your jobs in the buffer of the printer until a personal identification

number (PIN) is entered from the control panel. There is a default PIN for the printer driver; it appears in the

Job Information to the right of the Print and Hold options. The PIN must be four digits. This ensures the job

does not print until you are ready to retrieve it, and it ensures no one else using the printer can print the job.

• Select Verify to print one copy and hold all remaining copies in the printer memory. For example, you may

want to make sure the first copy is satisfactory before printing the remaining copies. After you print all the

copies, the Verify job is deleted from the printer memory.

• Select Repeat to print the originally requested copies of the print job, and then store the job in memory so

you can print additional copies later. You can print additional copies as long as the job remains stored in

memory.

• Select Reserve if you do not want to print the job immediately, but want to store the job in memory so you

can print it later. The job is held in memory until you delete it from the Held Jobs menu.

Note: Reserve and Repeat print jobs may be deleted if the printer requires extra memory to process additional held

jobs.

4 Click OK.

To use the confidential Print and Hold function from the command line of a Sun Solaris, HP-UX, IBM AIX, or Linux with

CUPS system, enter the following command:

# lp -d queue_name -o print_hold=confidential -o pin_no=pin file_name

To use the confidential Print and Hold function from the command line of a Linux with the LPRng system, enter the

following command:

# lpr -P queue_name -C "lexopts:print_hold=confidential pin_no=pin"

file_name

Note: Not all printers support the Print and Hold feature. See the printer documentation to determine if the printer

supports this feature.

Lexmark Dot Matrix Manual

Other manuals for Lexmark Dot Matrix