Use To
Timeouts
Screen Timeout
15–300 sec
Set the amount of time in seconds the printer waits before
returning the display to the Ready state.
Note: “30 sec” is the factory default setting.
Timeouts
Print Timeout
Disabled
1–255 sec
Set the amount of time in seconds the printer waits to receive an
end‑of‑job message before canceling the remainder of the print
job.
Notes:
• “90 sec “is the factory default setting.
• When the timer expires, any partially printed page still in the
printer is printed, and then the scanner checks to see if any
new print jobs are waiting.
• Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print jobs.
Timeouts
Wait Timeout
Disabled
15–65535 sec
Set the amount of time in seconds the printer waits for additional
data before canceling a print job.
Notes:
• “40 sec” is the factory default setting.
• Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL
emulation print jobs.
Error Recovery
Auto Reboot
Reboot when idle
Reboot always
Reboot never
Automatically reboot the printer back into the normal operation.
Note: “Reboot when idle” is the factory default setting.
Error Recovery
Max Auto Reboots
1‑20
Determine the number of automatic reboots the printer can
perform.
Note: 5 is the factory default setting.
Print Recovery
Auto Continue
Disabled
5–255
Let the printer automatically continue printing from certain offline
situations when these are not resolved within the specified time
period.
Note: Disabled is the factory default setting.
Print Recovery
Jam Recovery
On
Off
Auto
Specify whether the printer reprints jammed pages.
Notes:
• Auto is the factory default setting. The printer reprints
jammed pages unless the memory required to hold the
pages is needed for other printer tasks.
• On sets the printer to always reprint jammed pages.
• Off sets the printer to never reprint jammed pages.
Understanding the printer menus 120
To Next Page
Loading...
Need help?
General
