Lightware HDMI-3D-OPT-TX210A User Manual

11.4. Maximum ber cable extensions
OM1 OM2 OM3 OM4
(62.5/125) (50/125) (50/125) (50/125)
1080p@60Hz 24 bpp 250 m 600 m 1200 m 2500 m
1080p@60Hz 36 bpp 150 m 400 m 800 m 1300 m
4096x2048@30Hz 24 bpp Not supported 350 m 700 m 1100 m
11.5. Content of backup le
The backup le contains numerous settings and parameters saved from the device. When
the le is uploaded to a device, the followings will be overwritten:
Local serial port
RS-232 mode, Control protocol, Baud rate, Data bits, Stop bits, Parity
Port name and CI (Command Injection) port number
HDMI input port(s)
Video port name, Audio port name, HDCP setting
DP input port
Video port name, Audio port name, HDCP setting
DVI-D input port
Video port name, Audio port name, HDCP setting
Analog audio input ports
Volume, Balance, Gain, Port name
Crosspoint settings
Audio autoselect settings, Mute ports, Lock ports, Switch ports
Video autoselect settings, Mute ports, Lock ports, Switch ports
Optical output port
Video port name, Audio port name
Test pattern mode, clock source, and type
HDCP mode, HDMI mode
RS-232 mode, Control protocol, CI port number, Port name
Remote port name, Enabled/Disabled setting
Local output port
Port name, HDCP mode, HDMI mode, Power +5V mode
Test pattern mode, clock source, and type
Network settings
DHCP status (enable / disable)
Static IP address, Network mask, Gateway address
Further settings
GPIO port names, directions (input/output), and levels (high/low)
User EDID data (U1-U14)
Event manager: settings of all Events (1-20)
HDMI-3D-OPT-TX200 series
User’s manual
Appendix Page 103 / 106

Lightware HDMI-3D-OPT-TX210A Specifications

General

Brand	Lightware
Model	HDMI-3D-OPT-TX210A
Category	Extender
Language	English