Lightware HDMI-3D-OPT-TX210A User Manual

10. Troubleshooting
Usually, if the system seems not to transport the signal as expected, the best strategy for
troubleshooting is to check signal integrity through the whole signal chain starting from
source side and moving forward to receiver end.
At rst, check front panel LEDs and take the necessary steps according to their states. For
more information about status, LEDs refer to section 2.4 on page 12 and section 2.6 on
page 14.
Symptom Root cause Action Refer to
Video signal
No picture on
the video output
(receiver)
Device or devices
are not powered
properly
Check the extenders and
the other devices if they
are properly powered; try to
unplug and reconnect them.
Section 2.7
Cable connection
problem
Cables must t very well,
check all the connectors
(video and optical cables).
Section 2.2
Not the desired
port is selected
Check the Crosspoint
settings.
Section 6.3
Laser is disabled
Check laser mode in the
LINKOUT properties.
Section 6.4
Autoselect is
“disconnected”
If the Autoselect is enabled,
check the settings.
Section 6.4.4
The output is
muted
Check the mute state of
output ports.
Section 6.4.2
Display is not able
to receive the
video format
Check the emulated EDID;
select another (e.g. emulate
the display’s EDID on the
input port).
Section 6.5.1
HDCP is disabled
Enable HDCP on the input
port.
Section 6.4.8
Not the
desired picture
displayed on the
video output
Video output is
set to test pattern
(no sync screen)
statically
Check No sync screen
settings in the LINKOUT
properties.
Section 6.4
Video output is set
to test pattern (no
sync screen) as
there is no picture
on video source
Check video settings of the
source.
HDMI-3D-OPT-TX200 series
User’s manual
Troubleshooting Page 97 / 106

Lightware HDMI-3D-OPT-TX210A Specifications

General

Brand	Lightware
Model	HDMI-3D-OPT-TX210A
Category	Extender
Language	English