2.3. Front view
HDMI-3D-OPT-TX210A and HDMI-3D-OPT-TX210RAK
SW4-OPT-TX240RAK
2.4. Front view legend
1
HDCP status LED Dark: video output signal is not encrypted with HDCP.
Lights: video output signal is encrypted with HDCP.
2
USB USB interface for rmware upgrade and LDC connection.
3
HDMI in Connect an HDMI cable between the source and the transmitter.
Applied cable shall not be more, than 30 m (when the signal is
1080p) and 20 m (when the signal is 4K).
4
Audio1 in 3.5 mm Jack connector for asymmetric analog audio input signal.
5
Reset button Reset button reboots the extender. This is the same as
disconnecting the device from the power source and reconnecting
it again.
6
Audio select button Button for switching between audio sources.
7
Audio2 status LED LED gives feedback about actual connection status of Audio2
input port (on the rear side of device)
8
Show me button Special functions are available with this button (switch to bootload
mode, enable DHCP, restore factory default settings). For the
details about special functions see the section 5.1 on page 28.
9
DP in DisplayPort input connector. Applied cable shall not be more, than
40m (when signal is 1080p) and 25 m (when the signal is 4K)..
q
DVI-D in 29-pole DVI-I connector for DVI-D signal. Applied cable shall not
be more, than 30 m (when the signal is 1080p) and 20 m (when
the signal is 4K).
w
Video select button Switching among video inputs is available with this button.
e
Autoselect status
LED
Dark: autoselect function is OFF.
Blinks: searching for signal (the video LEDs also blink).
Lights: active video signal was found (the selected video LED
also lights).
Page 12 / 106 Installation and controls
To Next Page
Loading...
Need help?
General