Lightware HDMI-3D-OPT-TX210A User Manual

1.3. Model comparison
The available models have different features depending on the design. The following table
contains the most important differences of the models:
Ports
Optical
output *
Video ports
Audio
ports
Interface
ports
HDMI input
DP input
DVI-I input
HDMI output
Jack 3.5mm in
5-pole Phoenix in
RS-232
Ethernet
GPIO
Serial comm.
USB KVM
HDMI-3D-OPT-TX210A

- -
   
- - CT -
HDMI-3D-OPT-TX210RAK

- -
   
- -
CT
PT

SW4-OPT-TX240RAK
        
CT
PT
CI

CT = Control mode, PT = Pass-through mode, CI = Command injection mode. See more
information in section 4.3.1 on page 24.
* USB KVM function is under development, it will be added by rmware upgrade.
INFO
AV signal is always transmitted on ber optical interface.
1.4. Compatible devices
The transmitter is compatible with the following receivers and input boards:
▪ HDMI-3D-OPT-RX150RA receiver.
▪ MX modular frames with MX-DVI-OPT-IB and MX-HDMI-OPT-IB cards.
1.5. Features
INFO
Certain features depend on the conguration of the model. For more information about the
models see section 1.3 on page 8.
3D and 4K support
High bandwidth allows extension of resolutions up to 4K and even 3D sources and displays
are supported.
Signal transmission up to 2500 m
Video and audio signal transmission (DVI, HDMI or DisplayPort, and RS-232 over one
multi-mode ber optical cable).
Various audio and video connectors
DVI-I, HDMI, DisplayPort, Stereo jack, Phoenix.
GPIO control port
7 GPIO pins operating at TTL digital signal levels and can be controlled with both LW2 and
LW3 commands.
Page 8 / 106 Introduction

Lightware HDMI-3D-OPT-TX210A Specifications

General

Brand	Lightware
Model	HDMI-3D-OPT-TX210A
Category	Extender
Language	English