6.7.1. The Event editor
Press the Edit button in the desired Event line to open the Event editor window.
1
Event header
The name of the Event is displayed. Type the desired
name and press the Set name button. The Event can be
cleared by the Clear button. Use the tick mark to enable/
disable the Event.
2
Condition header
If the condition is set, the description (white colored text)
and the exact LW3 protocol expression (yellow colored
text) can be seen. If the advanced mode was used the
description is “Custom condition”.
3
Condition panel
The Wizard, the Advanced or the Link tool is available
to set the condition. The parameters and settings are
displayed below the buttons.
4
Condition test
The set condition can be tested to see the working
method in the practice.
5
Delay settings
The action can be scheduled to follow the condition after
the set time value.
6
Action header
If the action is set, the description (white colored text)
and the exact LW3 protocol expression (yellow colored
text) can be seen. If the advanced mode was used the
description is “Custom action”.
7
Action panel
The Wizard, the Advanced or the Link tool is available to
set the action. The parameters and settings are displayed
below the buttons.
8
Action test
The set action can be tested to see the working method
in the practice.
3
7
1
2
4
5
6
8
HDMI-3D-OPT-TX200 series
User’s manual
Software control Page 41 / 106
To Next Page
Loading...
Need help?
General