Lightware HDMI-3D-OPT-TX210A User Manual

6.7.3. Special tools and accessories
The name of the event
The name of a port can be changed by typing the new name and clicking the Set button.
The following characters are allowed when naming:
Letters (A-Z) and (a-z), and numbers (0-9).
Enable or disable an Event
The set Event can be enabled or disabled in the Event list, or directly in the Event editor
window by setting the tick mark beside the name.
Testing the condition
When the desired Condition is arranged, the setting can be tested. The Event list and the
Event editor contains a small panel that shows if the set condition is detected and how
many times. The Counter can be reset by the button in Event editor. If the Condition is true,
the detected mark turns green for two seconds and the Counter is increased.
Testing the action
The method is the same as testing the Condition, but in this case, the Action can be
triggered manually by pressing the Test button.
TIPS AND TRICKS
The Test button is also placed on the Action panel in the Event list. Thus, you can check the
Actions without opening the Event editor.
Delay the action
In most cases the Action is performed immediately after the Condition is detected. But
sometimes a delay is necessary between the Condition and the Action. Therefore, the new
Event manager contains the Delay panel which allows that feature with below settings:
▪ No delay: when the Condition is detected, the Action is launched.
▪ Simple delay: when the Condition is detected, the Action is launched after the set time
interval.
▪ Still exists: when the Condition is detected, the Action is launched after the set time
interval only if the Condition still exists.
▪ Continuously exists: when the Condition is detected, the Action is launched after the
set time interval only if the Condition has been existing continuously.
The available delay settings of an Event
TIPS AND TRICKS
Show advanced expressions option is a useful tool when you look for the path or value
of a property but just the expression is displayed. The option is available in the Event list
window or when Link tool is used.
Delay
Condition - true
Condition - true
Condition - true
Condition - true
continously
exist
still exist
simple delay
no delay
Perform the action
Perform the action
Delay
Delay
Perform the action
Condition - true
Perform the action
Time
HDMI-3D-OPT-TX200 series
User’s manual
Software control Page 43 / 106

Lightware HDMI-3D-OPT-TX210A Specifications

General

Brand	Lightware
Model	HDMI-3D-OPT-TX210A
Category	Extender
Language	English