Lippert Components Ground Control 2.0 User Manual

Rev:11.08.19 Page 137 CCD-0001573-08
Dual Jack Two-Valve System
NOTE: The jacks can be operated independently or
simultaneously.
1. Using the center portion of the switch, select
the left jack (roadside) by moving the switch
to the left; select both jacks by moving the
switch to the center; or select the right jack
(curbside) by moving the switch to the right
(Fig. 1).
2. Press the rocker switch to extend the jack(s)
(TRAILER UP) or retract the jack(s) (TRAILER
DOWN) (Fig. 1).
3. Release the switch when either the trailer
is level or stabilized or the jacks have been
completely retracted.
4. Turn the key to the LOCK/OFF position.
Dual Jack One-Valve System
1. Press the rocker switch to extend the jack(s)
(TRAILER UP) or retract the jack(s) (TRAILER
DOWN) (Fig. 2).
2. Release the switch when either the trailer
is level or stabilized or the jack(s) has been
completely retracted.
3. Turn the key to the LOCK/OFF position.
Single Jack One-Valve System
1. Press the rocker switch to extend the jack(s)
(TRAILER UP) or retract the jack(s) (TRAILER
DOWN) (Fig. 3).
2. Release the switch when either the trailer
is level or stabilized or the jack(s) has been
completely retracted.
3. Turn the key to the LOCK/OFF position.
Operation
Before operating the jacks, unlock the pendant switch to activate it (Figs. 1 and 2).
NOTE: The switch key should always be returned to the LOCK/OFF position after operating the jacks and
while towing the trailer.
Fig. 1
Fig. 2
Switch On/Off
Left Jack, Both
Jacks or Right Jack
Fig. 3
Switch On/Off
Switch On/Off
Extend
Retract
Extend
Retract
Extend
Retract

Lippert Components Ground Control 2.0 Specifications

General

Brand	Lippert Components
Model	Ground Control 2.0
Category	Lifting Systems
Language	English