Rev:11.08.19 Page 157 CCD-0001573-08
Always wear eye protection when performing service, maintenance or installation procedures.
Other safety equipment to consider would be hearing protection, gloves and possibly a full face
shield, depending on the nature of the task.
Moving parts can pinch, crush or cut. Keep clear and use caution.
The "CAUTION" symbol above is a sign that a procedure has a safety risk involved that may cause
personal injury and/or product damage, including voiding of warranty, if not performed safely and
in accordance with the safety procedures stated herein.
Instructions
Extending Stabilizers
1. Insert the pump handle into the bracket on the top of the pump (Fig. 1).
Fig. 1
The X-Trek Stabilizing System is to be used only for stabilization. Using the system for any other
purpose could cause damage the trailer and/or cause death or serious personal injury.
2. Make sure the pressure relief valve on the pump (Fig. 2) is closed by turning it to the right (clockwise).
3. Pump the handle up and down to start extending the stabilizers.
NOTE: The stabilizers will extend incrementally with each up and down stroke and will equalize force when
all the stabilizers have made contact with the ground.
4. When stabilizers have been extended to the desired level, remove the handle from the pump and
secure in the designated storage area.
Pump Handle
Pump
To Next Page
Loading...
Need help?
General
