EasyManuals Logo
Home>Lippert Components>Lifting Systems>Ground Control 2.0

Lippert Components Ground Control 2.0 User Manual

Lippert Components Ground Control 2.0
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
Rev:11.08.19 Page 52 CCD-0001573-08
People and pets should be clear of the trailer while the leveling system is operated. Never lift the
trailer completely o the ground. Lifting the trailer so the wheels are not touching the ground will
create an unstable and unsafe condition.
NOTE: The "ON" and "OFF" switch (Fig. 2A) controls the Power Tongue Jack's light only. If left on for an
extended period of time, the light will drain the trailer's battery.
NOTE: The Power Tongue Jack is designed for vertical movement of the trailer only.
Unhitching From A Tow Vehicle
1. Prior to unhitching from the tow vehicle, make sure the trailer is parked on a level surface and chock
the tires of the trailer.
2. Make sure the footpad of the Power Tongue Jack is pinned securely in place with the clevis pin and
hairpin cotter pin (Fig. 1B).
3. Disconnect any wires, chains, or sway control that may be equipped between the tow vehicle and the
trailer. Unlatch the trailer coupler.
4. Push "EXT" (Fig. 2C) two times holding on the third time approximately five seconds, then release the
switch. The Power Tongue Jack will automatically extend to the ground.
5. Push "EXT", again, until the coupler clears the hitch ball.
6. Move the tow vehicle away from the trailer.
7. Push "RET" (Fig. 2B) as needed to return the front of the trailer to level or use the Auto Level function
on the Touch Pad (Fig. 3D) to level the trailer. See "Auto Level" in "Auto Leveling Control Touch Pad"
section.
Fig. 1
B
A
B
C
A
Prior to Operation
The leveling system should only be operated under the following conditions:
1. Make sure the trailer is parked on solid and level ground. The locations should also be free of
surface depressions and moisture.
2. Make sure all persons, pets, and property are clear of the trailer while the leveling system is in
operation.
3. Make sure battery(ies) are fully charged at a minimum of 12V DC.
Operation - Power Tongue Jack
When parking the trailer on extremely soft surfaces, utilize load distribution pads under each jack.
Fig. 2

Table of Contents

Other manuals for Lippert Components Ground Control 2.0

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lippert Components Ground Control 2.0 and is the answer not in the manual?

Lippert Components Ground Control 2.0 Specifications

General IconGeneral
BrandLippert Components
ModelGround Control 2.0
CategoryLifting Systems
LanguageEnglish

Related product manuals