Rev:11.08.19 Page 20 CCD-0001573-08
Hitch Recognition
1. Turn on the touch pad.
2. Push the “UP” arrow (Fig. 5A) to scroll to “Auto Reconnect” option on LCD screen.
3. Push "ENTER" (Fig. 5B). The rear jacks and middle jacks (if equipped) will retract first, then the front jacks
will extend to raise the trailer to the height where the auto level sequence was started.
NOTE: If the auto level sequence was started with the front of the trailer in a below-level condition, the
Hitch Recognition will not function and the LCD will display “Feature Disabled.” In order for the
Hitch Recognition feature to function, the auto level sequence MUST be started with the front of
the trailer above level.
Troubleshooting
Manual Override
NOTE: For ease of manual override it is recommended to unplug the power harness to the motor prior to
performing the manual override procedure.
NOTE: Use of a 12-18 volt cordless screw gun or pneumatic screw gun is acceptable to manually override
the jacks. Do not use an impact screw gun to perform any of the override procedures, as this may
damage the motor. If manual override is necessary there are two options.
Fig. 5
A
B
Ensure the trailer is supported at both the front and rear with jack stands before performing any
troubleshooting or service to the trailer. Failure to do so may result in death or personal injury.
To Next Page
Loading...
Need help?
General
