GB-17
PreparationConnectionsInitial SetupUsing the FeaturesEPG (Electronic
Programme Guide)
Hints and Tips, Specification
and Safety Warnings
Using the DVD Features
Turning the TV on for the First Time
1. Connect the mains cable to the mains socket after you have
completed all the connections.
2. Switch on the POWER ON/OFF switch at the back of the TV. At
this stage, the TV switches to standby mode. The power LED on
the front panel of the TV will illuminate.
3. In standby mode, press the button on the side
panel of the TV or on the remote control to turn
the TV on.
7. A pop-up screen will be displayed, press the OK button on the
remote control to start the Auto Tuning.
Select Cancel on the screen or press the EXIT button to cancel
the new installation. An installation reminder will appear the next
time you turn on the TV.
Always disconnect the TV from the mains socket when not in use for a long period of time.
The button on the side panel of the TV or on the remote control is only used for switching the TV into standby,
it does not disconnect the TV from the mains power. To completely disconnect the mains power, please remove
the mains plug from the mains socket.
6. Press the button and then press the OK button or the
button to select Auto Tuning.
Initial Setup
Language
Auto Tuning
English
INSTALLATION GUIDE
Language
Auto Tuning
English
INSTALLATION GUIDE
To the mains socket
OFF ON
STANDBY
Language
Auto Tuning
English
INSTALLATION GUIDE
Please ensure aerial is plugged in!!
Then press OK button.
4. The first time you turn the TV on, it will go straight into the
INSTALLATION GUIDE menu. (If you have already installed
the TV using the Quick Start Guide, please go to the next step
“Selecting the Input Source” on the next page.)
5. The default on-screen menu language is set as English.
L26DVDB20_IB_final110210_running change4.indd 17 10/02/2011 3:43 PM
To Next Page
Loading...
Need help?
General
