4 -12
(6) Parking
Stop the tractor on a level surface, not a slope.
Disengage PTO and place all the transmission
shift levers in NEUTRAL position.
Lower the mounted implements on the ground.
Apply parking brake.
Stop engine and remove ignition key.
Before you leave the operator’s station, wait for
engine and all moving parts to stop.
Apply wheel chocks to the wheels when parking
the tractor on a slope unavoidably.
Turbocharger
▶If it is necessary to park the tractor on a slope, furthermore with loaded trailer, the
tractor may roll down, even though the parking brake is applied. In this case, apply
all the gears in lowest speed and apply wheel chocks or blocks to the all tires.
- Mechanical : downhill ⇒ reverse 1 gear / uphill ⇒ forward 1 gear.
- HST type : Apply the lowest gear of the range gear lever.
Caution
(7) Handling Turbocharger
(if fitted)
Before accelerating or working the tractor fitted
with the turbocharger, allow the engine to idle at
1000 rpm for about 1 minute to ensure that the
turbocharger is correctly lubricated.
Before stopping engine fitted with the
turbocharger, allow the engine to idle at 1000
rpm for about 2 minutes. This allows the
turbocharger and manifold to cool, preventing
deformation of the components.
After stopping engine fitted with the turbocharger,
cover the exhaust tail pipe to prevent the
turbocharger rotating in the wind, resulting in
possible damage to the bearings. The
turbocharger turbine must be prevented from
rotating freely with the engine off, as the shaft
bearings will not be lubricated.