Lutron Electronics RADIO RA2 User Manual

24/7 Technical Support—800.523.946638
|
Lutron®
device troubleshooting
Symptom Possible Cause Remedy
Creating the System
After attempting to add
a device, the Repeaters
beep 3 times.
The system is out of
device addresses.
If the system has less
than the maximum
number of devices, use
the RadioRA® 2 Design
and Setup PC Tool to
recover missing device
addresses.
While attempting to
add a Keypad, the
Keypad LEDs rapid-
flash for approximately
5seconds then go out.
Keypad is out of RF
range of the closest
Repeater.
Move a Repeater
closer to the device in
question. Additional
Repeaters may be
needed to provide
adequate coverage.
System not in Add
Mode.
Place system in Add
Mode.
While attempting to add
a device, the LEDs do
not slow flash.
Device is out of RF
range of the closest
Repeater.
Move a Repeater
closer to the device in
question. Additional
Repeaters may be
needed to provide
adequate coverage.
Device may be part of
another system.
If the device should be
in this system, reset
the device to factory
settings. Follow the
steps in resetting
devices to factory
settings.
TriathalonR Shades
only: It may take up to
60seconds before a
TriathalonR Shade LED
begins to flash.
Wait up to 60seconds
until the Shade LED
slow flashes before
adding.

Lutron Electronics RADIO RA2 Specifications

General

Brand	Lutron Electronics
Model	RADIO RA2
Category	Remote Control
Language	English